Speedometer repair lube pt 1 1.
Speedo cable lube tool.
I cut the tip off of the tube and squeezed the bottle expecting lube to come out.
I made this is a q.
Use back and forth strokes evenly over the entire cable surface stopping about 3 in.
I used it to lubricate the throttle and clutch cables on my 2005 cbr600rr.
Apply a liberal amount of grease on the cable from one end to the other.
I use a piece of white or light colored paper to do this on so no parts get lost.
Begin disassembly on a clean area approximately 2 by 3 so you have plenty of room to layout parts as you disassemble them.
If you do this where there might be a chance of a breeze tape down the paper or apply weights.
This video will show you the fastest way to lube your brake throttle clutch or any other cable you may have.
Lubricant was coming out of the end of the tool as i was spraying so it does not create a tight enough seal like i would have expected.
Check here for special coupons and promotions.
Your order may be eligible for ship to home and shipping is free on all online orders of 35 00.
The second method attacks the situation from the other end.
I received the lube before my parts came in so i didn t open it right away.
Founder i have pix of the speedometer in my 59 apache pegged at 110 mpg.
It would bounce all over while driving going from 10 mph to 110 mph like mad making a terrible racket until it.
Don t have a cable lube tool.
My speedometer cable was making an awefull racket whenever i would drive so i decided to fix the broblem and lube up my speedometer cable.
My new speedo cable gear came in so i was ready to lube the cable and put the cable back together.
Order speedometer cable for your vehicle and pick it up in store make your purchase find a store near you and get directions.
Even the smallest grains of sand that enter the speedometer cable housing can eventually destroy the cable by grooving or fraying it.
It s called a speedometer cable lubrication tool.
Overall still a very useful tool for maintaining your cables.
Do you have a p.
So i cut the tube in half long ways and it was dry.
This allows you to pump fresh lubricant up inside the cable.
